HPI Racing 1/8 Trophy 4.6 Truggy Nitro RTR
This is a glow powered, 2.4GHz radio controlled, ready to run 1/8 scale Trophy 4.6 Truggy Racer from HPI.
FEATURES
-Chassis: 6061 aluminum 0.12" (3mm) thick with front and rear metal rod braces
-Drive: Four wheel shaft, with steel outdrives and axles
-Engine: HPI Nitro Star F4.6 .28 cu in, 2.9hp, pull starter two-stage air filter with splash guard to prevent engine from getting flooded with water in wet conditions, composite 2-needle carb, ABC construction and large heatsink for efficient heat dissipation.
-Radio: 3-channel 2.4GHz with end point adjustment, servo reversing, steering dual rate, failsafe and waterproof servos for steering and throttle: TF-40 transmitter (HPIL5381), RF-40 recvr (HPIL5383)
-Radio Tray: Low profile aluminum
-Fuel Tank: 5.4oz (160cc)
-Differentials: Bevel Gear type with four internal gears for increased durability
-Shocks: Oil-filled, aluminum body
-Shock Towers: 6061 aluminum
-Brake: Dual drilled steel discs with fiber brake pads
-Suspension: Extra long arms for greater stability and thick suspension pins for greater resistance against crash damage
-Spur Gear: 46 tooth steel
-Steering: Bellcrank type with cast aluminum knuckles and servo saver
-Body: Painted and trimmed
-Bumpers: Plastic, tubular shaped front and rear
-Wheels: Seven spoke
-Tires: HPI Shredder Block
-Ball Bearings: Full set
-Caster: Adjustable, caster/toe-in refers to the angle of the frontsuspension when viewed from the side of the car in relation to the chassis
-Camber: Adjustable front and rear, camber refers to the angle of the tops of the tires from vertical when viewed from front or behind vehicle
INCLUDES
RTR 1/8 scale Trophy 4.6 Truggy Racer, .28 cu in Engine w/PullStarter, Body, Decals, 3-channel 2.4GHz Radio, Instructions.
REQUIREMENTS
-Nitro Car Fuel
-Nitro starter Kit
SPECIFICATIONS
Vehicle-
Length: 22.8" (580mm)
Width: 15.9" (405mm)
Height: 7.1" (180mm)
Tax extra as applicable.