DLE Hall Sensor Wire — Ignition Pickup Sensor for DLE 20 / 20RA / 30 / 35RA / 55 / 55RA / 61

Restore reliable ignition timing and smooth engine performance with this OEM-style Hall-effect pickup sensor, designed to fit DLE single-cylinder gas engines (20 / 20RA / 30 / 35RA / 55 / 55RA / 61).

Key Benefits

• Direct-fit replacement for common DLE single-cylinder engines — plug-and-play with stock ignition modules.
• Accurate timing via Hall-effect sensing for clean starts, stable idle, and consistent RPM in flight.
• Durable construction: heat- and vibration-resistant wiring with a sealed sensor housing.
• Compact & lightweight — designed to fit without adding bulk or weight to your engine bay.

Product Specifications

Installation Notes

• Fits into the existing DLE sensor bracket — no drilling or modification required in most installations.
• Confirm correct alignment so the flywheel magnet passes the sensor face within the recommended air-gap (too far = weak/no pulse).
• Route the pickup wire away from the ignition high-voltage lead and radio receiver wiring to reduce electrical interference.
• If splicing is required, use proper solder and heat-shrink to ensure a reliable connection.

Package Contents

• 1 × DLE Hall Effect Sensor Wire (Ignition Pickup)

Who This Is For

RC aircraft hobbyists, builders, and repair shops who need a reliable replacement for damaged or intermittent ignition pickups on DLE single-cylinder gas engines.

Quick Troubleshooting

• No ignition after install? Check connector seating and air-gap to the flywheel magnet.
• Intermittent signal? Re-route the wire away from the spark plug lead; verify the connector pinout matches your ignition module.
• Still not working? Measure the pickup output while rotating the flywheel — you should see a pulse from the sensor as the magnet passes.

Have a question about fitment? Message us with your engine model and ignition module type and we'll confirm compatibility.